AstroStart Security System VSS-113 Instalační příručka Strana 5

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 18
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 4
H1/4 ORANGE (+) Switched Ignition Input
Connect this wire to the (+) 12 volts ignition wire. This wire
is pre-wired to the starter kill relay and must show (+) 12
volts with the key in RUN position and during cranking.
Take great care that this wire cannot be shorted to the
chassis at any point.
TO IGNITION SYSTEM
H1/4 ORANGE
PRIMARY HARNESS
H1/5 BLACK (-) Chassis Ground Input
Connect this wire to a clean, paint-free sheet metal
location (driver kick panel) using a factory bolt that
DOES NOT have any vehicle component grounds
attached to it. A screw should only be used when in
conjunction with a two-sided lock washer. Under
dash brackets and door sheet metal are not
acceptable ground points. It is recommended that
all security components be grounded at the same location.
3 © 2006 Astroflex Electronics. – All rights reserved
H1/6 PURPLE (+) Door Trigger Input
Connect the PURPLE wire to a wire that shows (+)12V when any
door is opened. This wire will report Zone 3.
If using a door trigger wire that has a delay, the
Advanced Menu 2, feature 6 or the programming
tool can be used to turn Bypass Notification off.
H1/7 BLACK/WHITE (-) Instant Trigger Input
This input will respond to a negative input with an instant trigger. It is ideal for hood and trunk pins and will report on
Zone 1. It can also be used with single-stage sensors. The H1/7 BLACK/WHITE instant trigger wire can also be used to
shunt sensors during operation of auxiliary channels or remote start. (See Bypassing Sensor Inputs section of this
guide.)
H1/8 WHITE (-) Door Trigger Input
Most vehicles use negative door trigger circuits. Connect the WHITE
wire to a wire showing ground when any door is opened. When
connecting to newer model vehicles there is generally a need to use
individual door triggers. This wire will report Zone 3.
If using a door trigger wire that has a delay, the
Advanced Menu 2, feature 6 or the programming
tool can be used to turn Bypass Notification off.
VEHICLE (-)
DOOR SWITCH
H1/8 WHITE
DOME-LIGHT
+12V
VEHICLE (+)
DOOR SWITCH
H1/6 PURPLE
DOME-LIGHT
+12V
RING
CONNECTOR
FACTORY BOLT
GROUND
WIRE
NOTE: REMOVE ANY PAINT
BELOW RING CONNECTOR
Zobrazit stránku 4
1 2 3 4 5 6 7 8 9 10 ... 17 18

Komentáře k této Příručce

Žádné komentáře